-Two 1″x4″x8′ common board
-One 1″x4″x6′ common board
-1″ dowel
-Miter saw
-Drill
-Screws
How to make it:
-Out of 8′ boards: cut 5′ piece and 2′ piece
-Out of 6′ board cut two 3′ pieces
-Cut 3′ piece of 1″ dowel
-Cut one end of 5′ pieces and one end of 2′ pieces at a 15° angle using a miter saw.
-On the flat end of the 2′ boards, make two marks along the side at 3/8″ in from end and 1-1/4″ from the top and bottom.
-On one of the 3″ boards, make two marks on the end of the board at 3/8″ in from the sides and 1-1/4″ from the top and bottom.
-Pre-drill at these marks.
-Screw boards in place. This is the base of the stand. The 2′ boards should be on the outside of the 3′ board.
-On the other 3′ board, make two marks along the side of each end at 3/8″ in from end and 1-1/4″ from the top and bottom.
-On the flat end of the 5′ boards, make two marks on the end of the board at 3/8″ in from the sides and 1-1/4″ from the top and bottom.
-Pre-drill at these marks.
-Screw boards in place. This is the top of the stand. The 3′ board should be on the top of the 5′ boards.
-Measure 6″ down from top (flat end) of 5′ boards and 1-3/4″ in from sides and make a mark.
-Measure and mark to the center of the dowel.
-Pre-drill at these marks
-Screw dowel in place.
-Line up the angled end of the 5′ boards with the angled end of the 2′ boards so that the rack will be leaning towards the back of the stand. Hold in place and pre-drill two holes and screw in place.
-Caitlin