What you need:
-Block of wood
-Paint & paintbrushes
How to do it:
-Measure out the top of your block of wood, make marks where you will want the holes for your toothbrushes. Don’t make them too close together!
-Use a drill bit that will make a hole wide enough to fit a toothbrush down in and drill a hole at each mark you made.
-For instructions on how to get silhouettes to print, see this post.
-I printed mine at 1″ tall each, cut them out, and then traced them onto the wood.
-Grab an extra fine paint brush and fill them in!
If you liked this, here’s another wooden silhouette project.